White-rodgers 24A06G-1 Bedienungsanleitung PDF herunterladen

24A06G-1

DUAL LEVEL-TEMP

SILENT OPERATOR RELAY

(Normally Open Contacts)

INSTALLATION INSTRUCTIONS

Operator: Save these instructions for future use!

FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE

INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PERSONAL

INJURY AND/OR PROPERTY DAMAGE.

PRECAUTIONS

This Dual Level-Temp Silent Operator Relay is designed for con-

trolling two separate loads with a single low voltage thermostat.

It is especially suitable for use with electric heating equipment.

The Dual Level-Temp relay may be used to operate two separate

heating loads by means of a single low voltage thermostat. It

is equally well suited for use with a heating-cooling thermostat

to control heating and cooling loads alternately as in motels,

apartments, ofce buildings, etc.

This model Dual Level-Temp relay has a voltage input of 240

volts. Since this relay is equipped with a self-contained trans-

former, the supply voltage used must agree with the voltage

rating of the relay. This model has both an inductive and non-

inductive rating.

If in doubt about whether your wiring is millivolt, line, or low

voltage, have it inspected by a qualied heating and air con-

ditioning contractor, electrician, or someone familiar with basic

electricity and wiring.

Do not exceed the specication ratings.

All wiring must conform to local and national electrical codes

and ordinances.

This control is a precision instrument, and should be handled

carefully. Rough handling or distorting components could cause

the control to malfunction.

DESCRIPTION

SPECIFICATIONS

ELECTRICAL DATA

Switch Action: Two SPST switches, normally open

Thermal: Average time delay – 45 seconds

Ambient Temperature: -20° to 120°F (-24° to 49°C)

Mounting: 1/2" conduit hub or two key slot mounting holes

Thermostat Circuit Current:

Bimetal Heater #1 (Red & White Leads) – 0.21 Amps

Bimetal Heater #2 (Red & Black with White Stripe

Leads) – 0.21 Amps

The Silent Operator relay has been carefully adjusted at the fac-

tory, and no attempt should be made to adjust them in the eld.

CAUTION

To prevent electrical shock and/or equipment damage,

disconnect electric power to system at main fuse or

circuit breaker box until installation is complete.

WARNING

Do not use on circuits exceeding specied voltage.

Higher voltage will damage control and could cause

shock or re hazard.

PART NO. 37-4165D

Replaces 37-4165C

1236

www.white-rodgers.com

www.emersonclimate.com

TYPE

NUMBER

INPUT

VOLTAGE /FREQUENCY

ELECTRICAL RATING

FOR SWITCH #1

(Red and Black Leads)

FOR SWITCH #2

(Red Striped and Black Striped Leads)

NON-INDUCTIVE INDUCTIVE* NON-INDUCTIVE INDUCTIVE*

24A06G-1 240VAC, 60 Hz 25A, 6000W 12 FLA (72 LRA) 25A, 6000W 12 FLA (72 LRA)

*FLA - Full Load Amps.; LRA - Locked Rotor Amps.

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - 24A06G-1

24A06G-1DUAL LEVEL-TEMP SILENT OPERATOR RELAY (Normally Open Contacts)INSTALLATION INSTRUCTIONSOperator: Save these instructions for future use!FAILU

Seite 2 - WIRING AND OPERATION

2WR2-WIREHEATINGTHERMOSTATTYPE 24A06 DUAL LEVEL TEMPWHITEBLACKW/WHITESTRIPEREDBIMETALHEATER #1BIMETALHEATER #2SWITCH #1SWITCH #2TRANSFORMERHEATINGLOAD

Seite 3 - Line Voltage Low Voltage

3 WIRING AND OPERATION (cont.)All wiring should be done in accordance with local and national electrical codes and ordinances. WIRING Lin

Seite 4 - The Emerson logo is a

White-Rodgers is a business of Emerson Electric Co.The Emerson logo is a trademark and service mark of Emerson Electric Co.www.white-rodgers.comwww.e

Seite 5

www.white-rodgers.comwww.emersonclimate.comWhite-Rodgers est une affaire d’Emerson Electric Co.Le logo d’Emerson est une marque de commerce et une mar

Seite 6 - Basse tension

3 CÂBLAGE ET FONCTIONNEMENT (suite)Tout le câblage doit respecter les codes et règlements qui régissent les installations électriques. Fig. 3. Uti

Seite 7 - CÂBLAGE ET FONCTIONNEMENT

2INSTALLATION Le relais « Level-Temp » jumelé s’installe dans n’importe quelle position, sans que cela n’en détériore le rendement. On le raccorde à l

Seite 8 - TYPE 24A06G-1

DESCRIPTIONLe relais silencieux « Level-Temp » jumelé est conçu pour com-mander deux charges distinctes à l’aide d’un seul thermostat à basse tensi

Kommentare zu diesen Handbüchern

Keine Kommentare

White-rodgers 24A06G-1 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Mikrofone White-rodgers 24A06G-1 herunter. White Rodgers 24A06G-1 Manuel d'utilisation Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern